
Orange County, CA
Mold Inspection & Testing in Orange County, CA
Independent mold inspection and testing for Orange County property managers, facility and EHS teams and owners of office, lab and commercial buildings.
What we do
Citadel EHS investigates suspected mold in Orange County buildings by tracing the water. A consultant interviews the facility team, maps wet materials with moisture meters and infrared imaging, and samples where the result answers a question.
We do not sell remediation. The report records what is wet, what caused it and how far it extends, so it can be used to scope the repair or support a lease, a sale or a claim.
Our Irvine office, in the Irvine Spectrum, serves Irvine, Costa Mesa, Newport Beach, Anaheim, Tustin, Santa Ana, Huntington Beach, Lake Forest and Mission Viejo.
Mold in Orange County buildings
Orange County’s employers are concentrated in technology, medical device, biotech and advanced manufacturing. Those buildings, with offices, labs and light-industrial space under shared HVAC, tend to fail in particular ways: a rooftop unit or condensate line that leaks, a roof that was penetrated for new equipment, a tenant improvement that opened a wall.
CDPH lists leaky roofs, plumbing leaks, flooding and overflow from sinks and sewers among the common causes of indoor mold. We start with those, then check HVAC and ventilation, because moisture in a ceiling plenum can spread without leaving a stain.
Coastal cities such as Newport Beach and Huntington Beach have humid air, which matters most in buildings that are closed up and poorly ventilated.
What the rules say about mold testing in California
Mold is not regulated like asbestos. These points shape how we plan sampling for Orange County owners.
No federal mold limits
EPA states that no EPA or other federal limits have been set for mold or mold spores, so sampling cannot be used to check a building’s compliance with a federal mold standard.
EPA, A Brief Guide to Mold, Moisture and Your HomeSampling design
EPA says mold sampling should be conducted by professionals who have specific experience in designing mold sampling protocols, sampling methods and interpreting results.
EPA, A Brief Guide to Mold, Moisture and Your HomeHealth & Safety Code 26105(b)(5)
The Toxic Mold Protection Act directs the state health department, when it adopts standards to assess the health threat posed by mold, to ensure that air or surface testing is not required to determine whether mold in an indoor environment is a health threat.
California Health & Safety Code 26105
How an inspection works
Step 1
Intake call
You tell us the building, the complaint and the water history. We tell you whether sampling is likely to answer anything.
Step 2
Site visit
We take moisture readings and use infrared imaging, including at ceilings and HVAC equipment where water often hides.
Step 3
Sampling plan
We design the plan before sampling, with comparison samples from outdoors or unaffected space.
Step 4
Laboratory analysis
Samples go to a laboratory and the results come back for review.
Step 5
Written report
You receive findings, results and recommended next steps.
You receive a written report with our findings, the laboratory results and recommendations from an independent consultant.
On the ground
Our Irvine office
15635 Alton Pkwy Suite 200
Irvine, CA 92618
(714) 547-4301
Mold Inspection & Testing in Orange County: common questions
- Do you test offices and labs, not only apartments?
- Yes. Our Irvine office works with technology, medical device, biotech and manufacturing employers and with commercial property owners. The investigation is the same: find the water, map the damage, sample only where it helps.
- Does California require air testing to decide whether mold is a health threat?
- The Toxic Mold Protection Act directs the state health department to ensure its assessment standards do not require air or surface testing for that determination. EPA also says that where mold is visible, sampling is in most cases unnecessary.
- Is there an Orange County or California limit for mold?
- No federal limit exists, according to EPA, and CDPH reports that it found the evidence did not support state exposure limits in 2005. Results are read against outdoor and unaffected-area samples.
- Can moisture hide above the ceiling?
- Yes. Infrared imaging and moisture meters can show wet materials above and behind finishes, which is why we use them before choosing where to sample.
- Do you serve all of Orange County?
- Yes. Our Irvine office serves Irvine, Costa Mesa, Newport Beach, Anaheim, Tustin, Santa Ana, Huntington Beach, Lake Forest and Mission Viejo.
- What should we gather before the visit?
- The repair and leak history, the dates and places of past water events, and, for office and lab buildings, which HVAC zones serve the affected space. It lets us plan where to look first.
- Is moisture mapping enough, or do we need sampling too?
- Mapping shows where the building is wet. Sampling answers a specific question, such as comparing an affected area with outdoors. EPA says sampling should be designed by professionals with experience in mold sampling protocols, so we recommend it when it will change a decision.
- Do you do the cleanup?
- No. We are independent of the remediation trades. See our Orange County mold remediation page for the protocol and verification we provide.