San Francisco skyline with the Golden Gate Bridge

San Francisco Bay Area, CA

Mold Remediation in San Francisco & the Bay Area: Independent Oversight

Citadel EHS does not do the removal. We assess the building, write the protocol, oversee your contractor and perform post-remediation verification.

Photo: Gantavya Bhatt / Unsplash

What we do, and what we don’t

We do not do remediation labor. No Citadel crew will demolish drywall or set containment in your building. That work goes to a remediation contractor.

We assess the damage and the water source, write the protocol and scope, review contractor bids against it, oversee the work and perform post-remediation verification once the contractor says it is done.

Our independence from the contractor is the point. The party judging whether the space is clean is not the party being paid to clean it.

Why oversight matters in the Bay Area

Bay Area buildings often have limited room to work: tight walk-up stairwells, shared walls and stacked units. A protocol states how the work area is isolated, how debris leaves the building and how adjoining units are protected.

Where the water came from decides whether the job holds. If the source is a failed flashing, a drain or a bathroom exhaust that vents into an attic, removing the mold without fixing that sends the same call back to you next season.

On older buildings the tear-out may disturb asbestos-containing materials. The Bay Area Air Quality Management District requires a survey before renovation or demolition, covered below.

Guidance and rules that apply

No numeric mold limit exists to clear against, so remediation follows published guidance. The asbestos survey rule applies to the demolition or renovation that remediation often involves.

  • EPA guidance for commercial buildings

    EPA’s guidance on mold remediation in schools and commercial buildings says to use outside professionals with mold cleanup experience, check their references, and have them follow EPA’s recommendations, ACGIH guidelines or other professional guidelines.

    EPA, Mold Remediation in Schools and Commercial Buildings, Chapter 1
  • ANSI/IICRC S520

    The ANSI/IICRC S520 standard is a procedural standard for the remediation of mold-damaged structures and contents in residential, commercial and institutional buildings. The fourth edition was published in 2024.

    IICRC, ANSI/IICRC S520
  • CDPH on dampness and rental housing

    CDPH says dampness of habitable rooms and visible mold growth make a home substandard under California’s housing code, and that a rental owner cited as substandard by a local code inspector must repair the condition.

    CDPH, Mold and Dampness
  • BAAQMD Regulation 11, Rule 2, Section 303.8

    Before any demolition or renovation, the owner or operator must thoroughly survey the affected structure for asbestos-containing material. The survey is done by a person certified by the Division of Occupational Safety and Health who has passed an EPA-approved Building Inspector course, and it includes laboratory results.

    Bay Area AQMD, Regulation 11 Rule 2

How a remediation project runs

  1. Step 1

    Assessment

    We inspect the affected area, identify the water source and decide how far the work has to go.

  2. Step 2

    Protocol and scope

    We write the work to be done, how the area is contained and cleaned, and the criteria for clearing it.

  3. Step 3

    Bid review

    You choose who to invite. We help you compare their bids against the same scope.

  4. Step 4

    Oversight during the work

    We visit during the work, compare it with the protocol and record what we see.

  5. Step 5

    Post-remediation verification

    We inspect and sample against the criteria in the protocol before the space is cleared.

You receive the written protocol before work begins and a verification report afterwards, with our inspection findings and laboratory results.

Mold Remediation in San Francisco Bay Area: common questions

Do you remove the mold yourselves?
No. We are an independent consultant. We write the protocol, oversee your contractor and verify the result, but we do not do the removal.
Why separate the assessment from the removal?
A contractor that writes the scope and grades its own work has an interest in both. When we do neither, the scope and the verification are not tied to the removal revenue.
Does a tenant’s mold complaint trigger a remediation duty?
CDPH says visible mold can make a rental substandard when a local code enforcement officer cites it, and the owner must then repair. Whether a particular complaint is cited is for the local agency, and we can document the conditions.
Do we need an asbestos survey before tear-out?
In commercial buildings and in residential buildings with five or more units, the Bay Area rule requires a survey before renovation. For residential buildings of four or fewer units a survey is not required, though testing is required if certain materials are disturbed. Our San Francisco asbestos page covers the details.
What does clearance testing check?
The space against the criteria in the protocol, usually a visual inspection and sampling. EPA notes that surface sampling may help determine whether an area has been adequately cleaned or remediated.
Can you recommend a contractor?
We write the protocol so any qualified contractor can bid on the same scope. You choose.

Request a consultation

Mold Remediation in San Francisco Bay Area, CA

By submitting, you'll also receive our newsletter. You can unsubscribe at any time.

Inquiring about Mold Remediation in San Francisco Bay Area